It may take a few wiggles to remove some fused parts of the gears, but after that, you should be able to turn the gears. Make sure to calibrate your E-steps before 3D printing this. Some users had issues getting it to work, most likely due to their printing temperature being too high, or over extrusion. Many users had successful prints where the gears rotated perfectly. The designer has created multiple versions of this keychain, including one with larger gaps between the gears so it doesn’t fuse together from being too close. It’s possible to solve this issue by adding a flexible resin to your normal resin so it doesn’t grind and is not as brittle. One user tried 3D printing this model with a resin 3D printer and found that the friction of the spinning gears created dust. It has over 300 Makes, usually made with PLA or PETG. Geared Heart – Single Print with Moving Parts – Last Minute Giftĭo you plan of moving your lover’s heart! Then this keychain will do the magic, some have even given it to their wives. People have got good prints with both PLA and PETG even at a 200% scale, smaller scaled prints can result in poor bridging of the top part.Ĭheck out the spring-loaded box in action below.Ĭreated by Turbo_SunShine 2. There are two files for printing, one is a test file for the ‘sunshine-gear’ component for helping users to fine-tune their printer to 3D print the springs properly, and the other is the complete STL file for the spring-loaded box. In order to open and close the box, it uses a gear and spring model to open it, along with a small clip to keep it closed. To create this model, the designer recommends using a 0.2mm layer height or finer to print the overhangs successfully. You don’t need any supports or assembly, but you can still create a complex item using design special joints. This print-in-place Spring Loaded Box is an excellent example of the capabilities of 3D printing. Adjustable Angled Tablet Stand with Print-in-Place Hinges Crocodile Clips / Clamps / Pegs with Moving Jaws Phone/Tablet Stand – Flat Fold – Print-in-Place Fidget Spinner – One-Piece-Print / No Bearings Required! Geared Heart – Single Print with Moving Parts – Last Minute Gift
0 Comments
Leave a Reply. |